PoE power budget calculator
A PoE switch can only supply so many watts in total, whatever the number of ports. List the cameras, access points and other devices you want to power over the network cable, and see whether your switch can carry them, how much room is left, and which PoE standard each one needs.
| Device | Watts each | How many | Total | Port must support |
|---|
Worked out in your browser from the numbers you enter. Check the result against the data sheets of your own switch and devices before buying.
What a PoE budget is
Power over Ethernet sends electricity down the same cable as the data, so a camera or access point needs no power point. A PoE switch has two limits. Each port can supply up to the amount its PoE standard allows, and the whole switch can supply only its total budget. An eight-port switch whose ports can each give 30 watts may have a budget of 60 watts, not 240. When the devices ask for more than the budget, the switch refuses power to some ports, chosen by its port priority settings.
The PoE standards
| Standard | Usual name | Power leaving the switch port | Power guaranteed at the device | Typical devices |
|---|---|---|---|---|
| 802.3af | PoE | 15.4 W | 12.95 W | Phones, basic cameras, small access points |
| 802.3at | PoE+ | 30 W | 25.5 W | Most access points, cameras that pan, tilt and zoom |
| 802.3bt Type 3 | PoE++ | 60 W | 51 W | High-end access points, small switches powered by PoE |
| 802.3bt Type 4 | PoE++ | 90 W | 71.3 W | Displays, lighting, larger powered switches |
The difference between the two power columns is what the standard allows to be lost as heat in a full 100 metre cable. A newer port can power an older device: a PoE+ port runs an 802.3af camera without trouble. The reverse does not work, so a PoE+ access point on a plain PoE port may not start, or may run with features switched off.
Why keep some of the budget spare
- Devices draw more at some moments than others: a camera when its infrared lights or heater come on, an access point under load.
- Some switches set aside the full amount for a device's power class, not what it is using, so the budget fills faster than the sums suggest. The switch's manual says which method it uses.
- You will add a device later.
A switch that runs close to its limit also runs hotter. Planning to use no more than about 80% of the budget is a common rule of thumb, not a requirement of the standard.
Watch for passive PoE
The standards above are "active": the switch checks what is plugged in before it sends any power, so a laptop or printer on a PoE port is safe. Passive PoE, used by some older and low-cost equipment, puts a fixed voltage, commonly 24 volts, on the cable all the time with no check. It can damage a device that does not expect it, and it does not work with standard PoE devices. If a data sheet says "24V passive", match the injector or switch to that exact device.
Cable length and quality
An Ethernet run, including patch leads, should be no more than 100 metres. Use solid copper cable, Cat5e or better. Copper-clad aluminium cable, sold cheaply as CCA, has higher resistance, loses more power as heat and is outside the cabling standards, so it is a poor choice for PoE.
Related tools
Plan the networks those devices will sit on with the network and VLAN planner, which can keep cameras and smart devices apart from your main network, and work out address ranges with the subnet calculator.